Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC WITH IPDM E/R
Check "Self diagnostic result" with CONSULT. Refer to "DTC INDEX ".

Is the inspection result normal?

YES: GO TO 2.

NO: Repair or replace malfunctioning parts.

CHECK FUSE

Check that the following fuse are not fusing.

FUSE REFERENCE CHART

Signal name	Connection position	Fuse No.	Capacity
Ignition power supply	FUSE BLOCK (J/B)	3	10A

Is the fuse fusing?

YES: Repair the applicable circuit. And then replace the fuse.

NO: GO TO 3.

CHECK IGNITION RELAY FEEDBACK INPUT SIGNAL

Turn ignition switch OFF.
Disconnect BCM connector.

Check voltage between BCM harness connector and ground.

VOLTAGE REFERENCE CHART

(+)		(-)	Condition		Voltage (V) (Approx.)
BCM
Connector	Terminal
M123	123	Ground	Ignition switch	OFF	0
M123	123	Ground	Ignition switch	ON	Battery voltage

Is the inspection result normal?

YES: Replace BCM. Refer to , "REMOVAL AND INSTALLATION ".

NO: GO TO 4.

CHECK IGNITION RELAY FEEDBACK CIRCUIT

Disconnect fuse block (J/B) connector.

Check continuity between BCM harness connector and fuse block (J/B) harness connector.

CONTINUITY REFERENCE CHART

BCM		FUSE BLOCK (J/B)		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M123	123	M1	2A	Existed

Check continuity between BCM harness connector and ground.

CONTINUITY REFERENCE CHART

BCM		Ground	Continuity
Connector	Terminal
M123	123		Not existed

Is the inspection result normal?

YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair or replace harness.