Component Inspection

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ELECTRONIC CONTROLLED ENGINE MOUNT CONTROL SOLENOID VALVE

With CONSULT

Turn ignition switch OFF.
Reconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
Turn ignition switch ON.
Select "ENGINE MOUNTING" in "ACTIVE TEST" mode with CONSULT.

Check air passage continuity and operation delay time under the following conditions.

AIR PASSAGE CONTINUITY REFERENCE CHART

Condition (ENGINE MOUNTING)	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
TRVL	Existed	Not existed
IDLE	Not existed	Existed

Fig 1: Identifying Air Passages Of Electronic Controlled Engine Mount Control Solenoid Valve

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT

Turn ignition switch OFF.
Disconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.

Check air passage continuity and operation delay time under the following conditions.

AIR PASSAGE CONTINUITY REFERENCE CHART

Condition	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
12 V direct current supply between terminals 1 and 2	Existed	Not existed
No supply	Not existed	Existed

Is the inspection result normal?

YES: INSPECTION END

NO: Replace electronic controlled engine mount control solenoid valve. Refer to , "EXPLODED VIEW ".

Fig 2: Checking Air Passage Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.