Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Control System - Introduction (VQ35DE) (CROSSCABRIOLET)) >> System Description >> Diagnosis System (ECM) >> Diagnosis Description >> CONSULT Function >> Work Support Mode

Work Support Mode

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Work Item

WORK ITEMS CONDITION CHART

WORK ITEM CONDITION USAGE
FUEL PRESSURE RELEASE
  • Fuel pump will stop by touching "START" during idling. Crank a few times after engine stalls.
 When releasing fuel pressure from fuel line
IDLE AIR VOL LEARN
  • The idle air volume that keeps the engine within the specified range is memorized in ECM.
 When learning the idle air volume
SELF-LEARNING CONT
  • The coefficient of self-learning control mixture ratio returns to the original coefficient.
 When clearing mixture ratio self-learning value
EXH V/T CONTROL LEARN
  • In this mode, operation to learn exhaust valve timing control magnet retarder characteristic.
 When learning the exhaust valve timing control
EVAP SYSTEM CLOSE Close the EVAP canister vent control valve in order to make EVAP system close under the following conditions.
  • Ignition switch ON
  • Engine not running
  • Ambient temperature is above 0°C (32°F).
  • No vacuum and no high pressure in EVAP system
  • Fuel tank temperature is more than 0°C (32°F).
  • Within 10 minutes after starting "EVAP SYSTEM CLOSE"
  • When trying to execute "EVAP SYSTEM CLOSE" under the condition except above, CONSULT will discontinue it and display appropriate instruction.
    NOTE: When starting ENGINE, CONSULT may display "BATTERY VOLTAGE IS LOW. CHARGE BATTERY", even when in using a charged battery.
 When detecting EVAP vapor leakage in the EVAP system
VIN REGISTRATION
  • In this mode, VIN is registered in ECM.
 When registering VIN in ECM
TARGET IDLE RPM ADJ(1)
  • Idle condition
 When setting target idle speed
TARGET IGN TIM ADJ(1)
  • Idle condition
 When adjusting target ignition timing
CLSD THL POS LEARN
  • Ignition on and engine stopped.
 When learning the throttle valve closed position
(1) This function is not necessary in the usual service procedure.
scientia non olet · About Mike's Workshop Manuals