Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2010 >> M45 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Engine Control System - DTCS P0441 To P1212) >> DTC P0850: PNP Switch >> Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2010 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM COMPONENT FUNCTION CHECK

    With GST 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals under the following conditions.
      CONNECTOR TERMINAL VOLTAGE CHART

      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      M9 109 128 Selector lever P or N Battery voltage
      Except above Approx. 0
      Fig 1: Checking Voltage Between ECM Harness Connector Terminals
      G06306701Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Go to "DIAGNOSIS PROCEDURE ".

scientia non olet · About Mike's Workshop Manuals