Component Inspection

WARNING: This page is about a different car, the 2010 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION (APP) SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage ECM harness connector terminals under the following conditions.

Fig 1: Checking Voltage ECM Harness Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

CONNECTOR TERMINAL VOLTAGE CHART

ECM			Condition		Voltage (V)
Connector	+	-
Connector	Terminal	Terminal
M9	97 (APP sensor 1)	100	Accelerator pedal	Fully released	0.45 - 1.0
	97 (APP sensor 1)	100		Fully depressed	4.4 - 4.8
	98 (APP sensor 2)	104		Fully released	0.22 - 0.50
	98 (APP sensor 2)	104		Fully depressed	2.1 - 2.5

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
  INSPECTION END