Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2010 >> M35 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0441 To P1212 >> DTC P0448: EVAP Canister Vent Control Valve >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Turn ignition switch ON and wait at least 5 seconds.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Start engine and let it idle for at least 1 minute.
    4. Repeat next procedures 3 times.
      • Increase the engine speed up to between 3, 000 and 3, 500 RPM and maintain that speed for 2 minutes and 50 seconds to 3 minutes.

        Do not exceed 3 minutes  .

      • Fully released accelerator pedal and keep engine idle for approximately 5 seconds.
    5. Repeat next procedure 20 times.
      • Quickly increase the engine speed up to between 4, 000 and 4, 500 RPM and maintain that speed for 25 to 30 seconds.
      • Fully released accelerator pedal and keep engine idle for at least 35 seconds.
        Fig 1: Engine Speed Driving Pattern
        G05881230Courtesy of NISSAN MOTOR CO., U.S.A.
    6. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals