Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check ground connections M16, M70. Refer to "GROUND INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair or replace ground connections.

1. Disconnect EOT sensor harness connector.
2. Turn ignition switch ON.
3. Check the voltage between EOT sensor harness connector and ground.
   CONNECTOR TERMINAL VOLTAGE CHART
   
   

   EOT sensor		Ground	Voltage (V)
   Connector	Terminal
   F8	1	Ground	Approx. 5

   Fig 1: Checking Voltage Between ECT Sensor Terminal 1 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair open circuit, short to ground or short to power in harness or connectors.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between EOT sensor harness connector and ECM harness connector.
   CONNECTOR TERMINAL CONTINUITY CHART
   
   

   EOT sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F8	2	F106	84	Existed

4. Also check harness for short to ground and short to power.

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair open circuit, short to ground or short to power in harness or connectors.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 5.

NO: Replace engine oil temperature sensor.

Refer to "DESCRIPTION ".

INSPECTION END