Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2010 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (Engine Control System - Introduction (VQ40DE)) >> Function Diagnosis >> On Board Diagnostic (OBD) System >> Generic Scan Tool (GST) Function >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2010 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect GST to data link connector, which is located under LH dash panel near the hood opener handle.
    Fig 1: Identifying Data Link Connector And Brake Pedal
    G04894555Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation article.

    (*: Regarding GST screens in this article, sample screens are shown.)

    Fig 2: GST Display - Sample Screen
    G04874897Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Perform each diagnostic mode according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker. 

    Fig 3: GST Screens Display - Readiness Tests
    G04874898Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals