Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2010 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Security Control System) >> Without Intelligent Key System >> DTC/Circuit Diagnosis >> DTC P1610: Lock Mode >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ENGINE START FUNCTION
    1. Perform that DTC except DTC P1610 is not detected.

      If detected, erase the DTC after fixing.

    2. Turn ignition switch OFF.
    3. Turn ignition switch ON using the registered ignition key and wait for 5 seconds.
    4. Turn the ignition switch OFF and wait 5 seconds.
    5. Repeat steps  4 and 5 twice (a total of 3 times).
    6. Check that engine can start using the registered ignition key.

      INSPECTION END

scientia non olet · About Mike's Workshop Manuals