Procedure For Malfunction B

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-III.
3. Maintain the following conditions for at least 10 consecutive seconds.
   ENGINE OPERATING CONDITIONS
   
   

   ENG SPEED	1, 700 - 3, 175 RPM (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 70°C (158°F)
   Selector lever	1st or 2nd position
   Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

4. Check 1st trip DTC.
5. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

With GST

Follow the procedure "With CONSULT-III" above.