Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2009 >> M35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Supplemental Restraint System) >> Airbag System >> Data List/Active Test

Data List/Active Test

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Warm up the engine.
    2. Turn the ignition switch OFF.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical/SRS Airbag/Data List.
    7. According to the display on the Techstream, read the "Data List".

      SRS Airbag: 

      DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver Seat Position Driver Seat Position/ FORWARD: Seat position is forward
      BKWARD: Seat position is backward
      FAIL: Failure detected      		 FORWARD/BKWARD -
      Passenger Classification Passenger Classification/ NG: Data is not determined
      OFF: Vacant
      CHILD: Child (less than 36 kg (79.37 lb)) is seated
      AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
      AM50: Adult (more than 54 kg (119.05 lb)) is seated
      FAIL: A failure is detected      		 OFF/CHILD/AF05/AM50 -
      Driver Buckle SW Driver Buckle SW/ UNSET: The seat belt is not fastened
      SET: The seat belt is fastened
      NG: Data is not determined      		 UNSET/SET -
      Passenger Buckle SW Passenger Buckle SW/ UNSET: The seat belt is not fastened
      SET: The seat belt is fastened
      NG: Data is not determined      		 UNSET/SET -
      Display Type Information Display Type Information/ LR: The display is indicated by LH/RH
      DP: The display is indicated by Driver/Passenger      		 LR/DP -
      Number of Past DTC Number of Past DTC/ Min.: 0, Max.: 255 0 -
scientia non olet · About Mike's Workshop Manuals