Component Inspection
WARNING: This page is about a different variant/trim than selected.
- CHECK SNOW MODE SWITCH-I
- Turn ignition switch OFF.
- Disconnect snow mode switch harness connector.
- Check the continuity between snow mode switch terminals under the following conditions.
CONTINUITY REFERENCETerminals Condition Continuity 1 and 4 Snow mode switch ON Existed OFF Not Existed Is the inspection result normal?
YES: GO TO 2.
NO: Replace snow mode switch.
- CHECK SNOW MODE SWITCH-II
Check the continuity between snow mode switch terminals under the following conditions.
CONTINUITY REFERENCE
| Terminals (Polarity) | Continuity |
|---|---|
| 2 (+) - 4 (-) | Existed |
| 4 (+) - 2 (-) | Not Existed |
Is the inspection result normal?
YES: INSPECTION END
NO: Replace snow mode switch.