Component Function Check
WARNING: This page is about a different variant/trim than selected.
- CHECK ICC BRAKE SWITCH FUNCTION
With CONSULT-III
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
- Check "BRAKE SW1" indication under the following conditions.
MONITOR ITEM REFERENCE
| Monitor item | Condition | Indication | |
|---|---|---|---|
| BRAKE SW1 | Brake pedal (A/T) Brake pedal or clutch pedal (M/T) |
Slightly depressed | OFF |
| Brake pedal (A/T) Brake pedal and clutch pedal (M/T) |
Fully released | ON | |
Without CONSULT-III
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
VOLTAGE REFERENCE
| ECM | Condition | Voltage (V) | |||
|---|---|---|---|---|---|
| Connector | + | - | |||
| Terminal | Terminal | ||||
| M107 | 126 (ICC brake switch signal) | 128 | Brake pedal (A/T) Brake pedal or clutch pedal (M/T) |
Slightly depressed | Approx. 0 |
| Brake pedal (A/T) Brake pedal and clutch pedal (M/T) |
Fully released | Battery voltage | |||
Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE ".