Component Function Check
- PRECONDITIONING
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 12.8 V at idle.
- Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF.
GO TO 2.
- PERFORM COMPONENT FUNCTION CHECK
With CONSULT-III
- Start engine and let it idle.
- Select "BAT CUR SEN" in "DATA MONITOR" mode with CONSULT-III.
- Check "BAT CUR SEN" indication for 10 seconds.
"BAT CUR SEN" should be above 2, 300 mV at least once.
Without CONSULT-III
- Start engine and let it idle.
- Check the voltage between ECM harness connector terminals as per the following.
VOLTAGE REFERENCE
| ECM | Voltage (V) | ||
|---|---|---|---|
| Connector | + | - | |
| Terminal | Terminal | ||
| F102 | 91 (Battery current sensor signal) | 95 | Above 2.3 at least once |
Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE "