Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check ground connection M95. Refer to Ground Inspection in "CIRCUIT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair or replace ground connection.

1. Disconnect EVAP control system pressure sensor harness connector.
2. Check that water is not inside connectors.

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair or replace harness connector.

1. Turn ignition switch ON.
2. Check the voltage between EVAP control system pressure sensor harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   EVAP control system pressure sensor		Ground	Voltage (V)
   Connector	Terminal
   B252	3	Ground	Approx. 5

   Is the inspection result normal? 

   YES: GO TO  8.

   NO: GO TO 4.

Check harness for short to power and short to ground, between the following terminals.

Is the inspection result normal? 

YES: GO TO 5.

NO: Repair short to ground or short to power in harness or connectors.

Check the following.

• Battery current sensor (Refer to "COMPONENT INSPECTION ".)
• Camshaft position sensor (bank 1) (Refer to "COMPONENT INSPECTION ".)
• Crankshaft position sensor (Refer to "COMPONENT INSPECTION ".)
• Exhaust valve timing control position sensor (bank 1) (Refer to "COMPONENT INSPECTION ".)
• Manifold pressure sensor (Refer to "COMPONENT INSPECTION ".)

  Is the inspection result normal? 

  YES: GO TO 6.

  NO: Replace malfunctioning component.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO  9.

NO: GO TO 7.

1. Replace accelerator pedal assembly
2. Perform "SPECIAL REPAIR REQUIREMENT ".

   INSPECTION END

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 9.

NO: Replace EVAP control system pressure sensor.

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END