Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2009 >> EX35 Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Component Diagnosis >> U1000 Can Comm Circuit >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III 

    1. Start the engine.
    2. Run engine for at least 6 consecutive seconds at idle speed.
    3. Perform "Self Diagnostic Results" in "TRANSMISSION".

    With GST 

    Follow the procedure "With CONSULT-III"

    Is "U1000 CAN COMM CIRCUIT" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About Mike's Workshop Manuals