Physical Values
CONNECTOR TERMINALS REFERENCE CHART
| Terminal (Wire color) | Description | Condition | Reference value (Approx.) | |||
|---|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | |||
| 2 (L) | 3 (W) | Sound signal door speaker LH | Output | Ignition switch ON | Voice output | |
| 4 (LG) | 5 (Y) | Sound signal rear speaker LH | Output | Ignition switch ON | Voice output | |
| 6 (G) | 15 (B) | Steering switch signal A | Input | Ignition switch ON | Keep pressing SOURCE switch. | 0 V |
| Keep pressing ↑ switch. | 0.7 V | |||||
| Keep pressing ↓ switch. | 1.3 V | |||||
| Except for above. | 3.3 V | |||||
| 7 (V) | Ground | ACC power supply | Input | Ignition switch ACC | - | Battery voltage |
| 8 (B) | Ground | GND | - | Ignition switch ON | - | 0 V |
| 9 (L) | Ground | Illumination signal | Input | OFF | Lighting switch is OFF. | 0 V |
| Lighting switch is ON. | 12 V | |||||
| 11 (BR) | 12 (R) | Sound signal door speaker RH | Output | Ignition switch ON | Voice output | |
| 13 (L) | 14 (P) | Sound signal rear speaker RH | Output | Ignition switch ON | Voice output | |
| 15 (B) | Ground | Steering switch signal GND | - | Ignition switch ON | - | 0 V |
| 16 (L) | 15 (B) | Steering switch signal B | Input | Ignition switch ON | Keep pressing VOL DOWN switch. | 0 V |
| Keep pressing VOL UP switch. | 0.7 V | |||||
| Except for above. | 3.3 V | |||||
| 19 (Y) | Ground | Battery power supply | Input | Ignition switch OFF | - | Battery voltage |
| 20 (B) | Ground | GND | - | Ignition switch ON | - | 0 V |
| 22 (R) | 21 (W) | Satellite radio sound signal LH | Input | Ignition switch ON | When satellite radio mode is selected | |
| 24 (B) | 23 (G) | Satellite radio sound signal RH | Input | Ignition switch ON | When satellite radio mode is selected | |
| 25 | - | Shield | - | - | - | - |
| 26 | - | Shield | - | - | - | - |
| 28 (W) | Ground | Request signal (SAT→CONT) | Input | Ignition switch ON | When satellite radio mode is selected | |
| 29 (B) | Ground | Communication signal (SAT→CONT) | Input | Ignition switch ON | When satellite radio mode is selected | |
| 30 (R) | Ground | Communication signal (CONT→SAT) | Output | Ignition switch ON | When satellite radio mode is selected | |
| 33 | - | FM sub | Input | - | - | - |
| 34 | - | AM-FM main | Input | - | - | - |
| 35 | Ground | Antenna amp. ON signal | Output | Ignition switch ACC | - | 12 V |
| 36 (R) | Ground | AUX image signal | Output | Ignition switch ON | At AUX image is displayed | |
| 37 (L) | Ground | AUX image GND | - | Ignition switch ON | - | 0 V |
| 38 (P) | Ground | RGB signal (B: blue) | Output | Ignition switch ON | Start confirmation/adjustment mode, and then display color bar by selecting "Color Spectrum Bar" on DISPLAY DIAGNOSIS screen. | |
| 39 (L) | Ground | RGB signal (G: green) | Output | Ignition switch ON | Start confirmation/adjustment mode, and then display color bar by selecting "Color Spectrum Bar" on DISPLAY DIAGNOSIS screen. | |
| 40 (G) | Ground | RGB signal (R: red) | Output | Ignition switch ON | Start confirmation/adjustment mode, and then display color bar by selecting "Color Spectrum Bar" on DISPLAY DIAGNOSIS screen. | |
| 41 (Y) | Ground | RGB synchronizing signal | Output | Ignition switch ON | - | |
| 42 | - | Shield | - | - | - | - |
| 43 (P) | Ground | RGB area (YS) signal | Output | Ignition switch ON | At RGB image is displayed | 5 V |
| At AUX image is displayed | ||||||
| 44 (G) | Ground | Communication signal (DISP→CONT) | Input | Ignition switch ON | When adjusting display-brightness. | |
| 45 (LG) | Ground | Horizontal synchronizing (HP) signal | Input | Ignition switch ON | - | |
| 46 (LG) | Ground | Signal GND | - | Ignition switch ON | - | 0 V |
| 47 (O) | Ground | Signal VCC | Output | Ignition switch ACC | - | 9 V |
| 49 | - | Shield | - | - | - | - |
| 50 | - | Shield | - | - | - | - |
| 55 | - | Shield | - | - | - | - |
| 56 (L) | Ground | Communication signal (CONT→DISP) | Output | Ignition switch ON | When adjusting display-brightness. | |
| 57 (GR) | Ground | Vertical synchronizing (VP) signal | Input | Ignition switch ON | - | |
| 58 (BR) | Ground | Inverter GND | - | Ignition switch ON | - | 0 V |
| 59 (Y) | Ground | Inverter VCC | Output | Ignition switch ACC | - | 9 V |
| 66 (R) | Ground | AUX image signal | Input | Ignition switch ON | When AUX mode is selected | |
| 73 | - | Shield | - | - | - | - |
| 74 (L) | Ground | AUX image signal GND | - | Ignition switch ON | - | 0 V |
| 85 (B) | Ground | GND | - | Ignition switch ON | - | 0 V |
| 86 (L) | - | CAN-H | Input/Output | - | - | - |
| 87 (P) | - | CAN-L | Input/Output | - | - | - |
| 88 (SB) | - | AV communication signal (H) | Input/Output | - | - | - |
| 89 (W) | - | AV communication signal (L) | Input/Output | - | - | - |
| 90 (L) | - | AV communication signal (H) | Input/Output | - | - | - |
| 91 (P) | - | AV communication signal (L) | Input/Output | - | - | - |
| 95 (L) | Ground | AUX sound signal RH | Input | Ignition switch ON | When AUX mode is selected | |
| 96 (W) | Ground | AUX sound signal LH | Input | Ignition switch ON | When AUX mode is selected | |
| 97 | - | Shield | - | - | - | - |
| 101 (BR) | Ground | SW GND | - | Ignition switch ON | - | 0 V |
| 103 (LG) | Ground | Eject signal | Input | - | Pressing the eject switch | 0 V |
| Except for above | 3.3 V | |||||
| 104 (G) | Ground | Ignition signal | Input | Ignition switch ON | - | Battery voltage |
| 105 (O) | Ground | Reverse signal | Input | Ignition switch ON | R position | 12 V |
| Other than R position | 0 V | |||||
| 106 (SB) | Ground | Parking brake signal | Input | Ignition switch ON | Parking brake ON | 0 V |
| Parking brake OFF | ||||||
| 107 (GR) | Ground | Vehicle speed signal (8-pulse) | Input | Ignition switch ON | When vehicle speed is approx. 40 km/h (25 MPH) |
NOTE:
Maximum voltage may be 12 V due to specifications (connected units).
|