Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2008 >> G35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake Control System) >> Removal And Installation >> Steering Angle Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove spiral cable. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the screws and remove the steering angle sensor.
    CAUTION: In the case that the ABS actuator and electronic unit (control unit) is replaced, make sure to adjust position of steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : SPECIAL REPAIR REQUIREMENT ".
scientia non olet · About Mike's Workshop Manuals