Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2008 >> FX35 AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P0137 Through P0445 (VQ35DE) >> DTC P0181 FTT Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Wait at least 10 seconds.

    If the result is NG, go to "DIAGNOSTIC PROCEDURE ".

    If the result is OK, go to following step.

  4. Check "COOLAN TEMP/S" value.

    If "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" is less than 60°C (140°F).
    Fig 1: CONSULT-III Display - DATA MONITOR
    G04900167Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Wait at least 10 seconds.
  7. Check 1st trip DTC.
  8. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals