Diagnosis Procedure

1. Turn ignition OFF.
2. Disconnect power window main switch connector.
3. Turn ignition switch ON.
4. Check voltage between power window main switch harness connector and ground.
   VOLTAGE SPECIFICATION
   
   

   (+)		(-)	Voltage (V) (Approx.)
   Power window main switch
   Connector	Terminal
   D8	10	Ground	Battery voltage
   D9	19

Is the inspection result normal? 

YES: GO TO  2.

NO: GO TO  3.

1. Turn ignition switch OFF.
2. Check continuity between power window main switch harness connector and ground.
   CONTINUITY SPECIFICATION
   
   

   Power window main switch		Ground	Continuity
   Connector	Terminal
   D9	17		Existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair or replace harness.

1. Turn ignition switch OFF.
2. Disconnect BCM connector.
3. Check continuity between BCM harness connector and power window main switch harness connector.
   CONTINUITY SPECIFICATION
   
   

   BCM		Power window main switch		Continuity
   Connector	Terminal	Connector	Terminal
   M118	2	D9	19	Existed
   	3	D8	10

4. Check continuity between BCM harness connector and ground.
   CONTINUITY SPECIFICATION
   
   

   BCM		Ground	Continuity
   Connector	Terminal
   M118	2		Not existed
   	3

Is the inspection result normal? 

YES: Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO: Repair or replace harness.