ID Registration With Transmitter Activation Tool

1. With the ignition switch in OFF position, connect the CONSULT scan tool to the Data Link Connector (DLC).
2. Turn ignition switch to ON position.
3. Select "START (NISSAN BASED VHCL)".
4. Touch "BCM" on "SELECT SYSTEM" screen.
5. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
6. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
7. With the Transmitter Activation Tool pushed against the front left transmitter tire air valve, press the button for 5 seconds. See Fig 1.
8. Register the IDs in the specified order. See ID REGISTRATION ORDER SPECIFICATIONS  table. When ID registration of each wheel has been completed, a buzzer sounds as indicated in the table below and the hazard warning light flashes.
   ID REGISTRATION ORDER SPECIFICATIONS
   
   

   Tire Position	Buzzer Will Sound
   Front Left	Once
   Front Right	2 Times
   Rear Right	3 Times
   Rear Left	4 Times

   NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
9. After completing all ID registrations, press "END" to complete the procedure.

Fig 1: Identifying Transmitter Activation Tool (J-45295)

Courtesy of NISSAN MOTOR CO., U.S.A.