With CONSULT-II

Start engine and warm it up to normal operating temperature.
Select "A/F SEN1 (B1)" in "DATA MONITOR" mode with CONSULT-II.
Check "A/F SEN1 (B1)" indication.
If the indication is constantly approx. 2.2V and does not fluctuates, go to "DIAGNOSTIC PROCEDURE ".

If the indication fluctuates around 2.2V, go to next step.
Select "A/F SEN1 (B1) P1276" (for DTC P0130) of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT-II.
Touch "START".

When the following conditions are met, "TESTING" will be displayed on the CONSULT-II screen.

CONDITION CHART

If "TESTING" is not displayed after 20 seconds, retry from step 2.

Fig 1: CONSULT-II Display - OUT OF CONDITION

Courtesy of NISSAN NORTH AMERICA, INC.

Release accelerator pedal fully.
NOTE: Never apply brake during releasing the accelerator pedal.

Fig 2: CONSULT-II Display - TESTING
Courtesy of NISSAN NORTH AMERICA, INC.
Make sure that "TESTING" changes to "COMPLETED".
If "TESTING" changed to "OUT OF CONDITION", retry from step 6.
Make sure that "OK" is displayed after touching "SELF-DIAG RESULT".
If "NG" is displayed, go to "DIAGNOSTIC PROCEDURE ".

Fig 3: CONSULT-II Display - COMPLETED
Courtesy of NISSAN NORTH AMERICA, INC.