Diagnostic Procedure

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check voltage between ECM terminal 121 and ground with CONSULT-II or tester.

   Voltage: Battery voltage 

   Fig 1: Checking ECM Voltage

   Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: GO TO  3.

NG: GO TO 2.

Check the following.

• IPDM E/R connector E121
• 20A fuse
• Harness for open or short between ECM and battery

  Repair or replace harness or connectors.

Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness or connectors.

With CONSULT-II 

1. Turn ignition switch ON.
2. Select "SELF DIAG RESULTS" mode with CONSULT-II.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure. 

   See "DTC CONFIRMATION PROCEDURE ".

5. Is the 1st trip DTC P0603 displayed again?

With GST 

1. Turn ignition switch ON.
2. Select Service $04 with GST.
3. Perform DTC Confirmation Procedure. 

   See "DTC CONFIRMATION PROCEDURE ".

4. Is the 1st trip DTC P0603 displayed again?

Yes or No 

Yes: GO TO 5.

No: INSPECTION END 

1. Replace ECM.
2. Perform initialization of IVIS(NATS) system and registration of all IVIS(NATS) ignition key IDs. Refer to "ECM RE-COMMUNICATING FUNCTION ".
3. Perform "VIN REGISTRATION ".
4. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
5. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
6. Perform "IDLE AIR VOLUME LEARNING ".

   INSPECTION END