Consult-II Main Function
WARNING: This page is about a different variant/trim than selected.
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
CONSULT-II MAIN FUNCTION TABLE
| Mode | Function | Reference |
|---|---|---|
| SELF-DIAG RESULTS | Receives self-diagnosis results from RAS control unit and indicates DTCs. | ,"SELF-DIAGNOSIS " |
| DATA MONITOR | Receives input/output signals from RAS control unit and indicates and stores them to facilitate locating cause of malfunctions. | ,"DATA MONITOR " |
| CAN DIAG SUPPORT MNTR | Monitors transmitting/receiving status of CAN communication. | ,"CAN COMMUNICATION " |
| ACTIVE TEST | Sends command to RAS actuator to change output signals and check operation of output system. | ,"ACTIVE TEST " |
| ECU PART NUMBER | Displays RAS control unit part number. | ,"CONTROL UNIT PART NUMBER " |