Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2006 >> M35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Transfer Case) >> Trouble Diagnosis For System >> Wait Detection Switch >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2006 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "OFF". (Stay for at least 5 seconds.)
  2. Disconnect wait detection switch harness connector.
  3. Remove wait detection switch. Refer to "LOCATION OF ELECTRICAL PARTS ".
  4. Push and release wait detection switch and check continuity between wait detection switch terminals 10 and 11.
    TERMINALS CONTINUITY CHART

    Terminal Condition Continuity
    10 - 11 Push wait detection switch Yes
    Release wait detection switch No
    Fig 1: Identifying Continuity Between Wait Detection Switch Terminals 10 And 11
    G04133973Courtesy of NISSAN MOTOR CO., U.S.A.
  5. If NG, replace the wait detection switch. Refer to "LOCATION OF ELECTRICAL PARTS ".
scientia non olet · About Mike's Workshop Manuals