Glass Hatch Switch Circuit Inspection

WARNING: This page is about a different car, the 2006 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

CHECK GLASS HATCH SWITCH

Turn ignition switch OFF.
Disconnect glass hatch switch.

Check continuity between glass hatch switch terminal 2 and ground.

TERMINALS CONTINUITY CHART

Connector	Terminals		Condition	Continuity
Connector	(+)	(-)	Condition	Continuity
D710	2	Ground	With the glass hatch switch pressed	No
D710	2	Ground	With the glass hatch switch released	Yes

OK or NG

OK : GO TO 2.
NG : Replace glass hatch switch.

Fig 1: Identifying Continuity Between Glass Hatch Switch Terminal 2 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK HARNESS CONTINUITY
1. Disconnect BCM.
2. Check continuity between BCM connector M18 terminal 30 and glass hatch switch connector D710 terminal 2.
  30 - 2 : Continuity should exist.
3. Check continuity between BCM connector M18 terminal 30 and ground.
  30 - Ground : Continuity should not exist.
OK or NG
- OK : Glass hatch switch circuit is OK.
- NG : Repair or replace harness.
  
  Fig 2: Identifying Continuity Between BCM Connector M18 Terminal 30 And Glass Hatch Switch Connector D710 Terminal 2
  Courtesy of NISSAN MOTOR CO., U.S.A.