Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2006 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Control System - Component Testing (VK45DE)) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

WARNING: This page is about a different car, the 2006 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONTINUITY CONDITIONS

    Condition Continuity
    Brake pedal: Fully released. Should not exist
    Brake pedal: Slightly depressed. Should exist
  4. If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.
    Fig 1: Identifying Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04075261Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals