Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2006 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Control System - Introduction (VK45DE)) >> Trouble Diagnosis >> Generic Scan Tool (GST) Function >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2006 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect "GST" to data link connector, which is located under LH dash panel near the hood opener handle.
    Fig 1: Identifying Data Link Connector And Brake Pedal
    G04074601Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation manual.

    (*: Regarding GST screens in this section, sample screens are shown.)

    Fig 2: Generic Scan Tool Display
    G04074602Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Perform each diagnostic mode according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker. 

    Fig 3: Generic Scan Tool Display - OBD II FUNCTIONS
    G04074603Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals