Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2005 >> G35 x >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 45 (IPDM E/R (Intelligent Power Distribution Module Engine Room) - Coupe) >> IPDM E/R (Intelligent Power Distribution Module Engine Room) >> Auto Active Test >> Operation Procedure

Operation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Close hood and front door (passenger side) and then lift wiper arms away from windshield (to prevent glass damage by wiper operation).
    NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.
  2. Turn ignition switch OFF.
  3. Turn ignition switch ON, and within 20 seconds, press drivers door switch 10 times (close other door).

    Then turn ignition switch OFF.

  4. Turn ignition switch ON within 10 seconds after ignition switch OFF.
  5. When auto active test mode is actuated, horn chirps once. Oil pressure warning lamp starts blinking.
  6. After a series of operations is repeated three times, auto active test is completed.
    NOTE: When auto active test mode has to be cancelled halfway, turn ignition switch OFF.
    CAUTION: Be sure to inspect door switch when the auto active test cannot be performed. See CHECK DOOR SWITCH .
scientia non olet · About Mike's Workshop Manuals