Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2005 >> G35 Base, 2D Coupe, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System - Sedan) >> DTC P0451: EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and wait at least 40 seconds.
    NOTE: Do not depress accelerator pedal even slightly.

    If 1st trip DTC is detected, go to "Diagnostic Procedure ".

    Fig 1: Selecting "DATA MONITOR" Mode With CONSULT-II
    G02348626Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals