Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2005 >> FX35 AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System - VQ35DE >> DTC P1706: PNP Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-II. Then check the "P/N POSI SW" signal under the following conditions.
    Fig 1: Identifying CONSULT-II Display Screen Data Monitor
    G02361038Courtesy of NISSAN MOTOR CO., U.S.A.
    P/N POSI SW CHART

    Position (Selector lever) Known-good signal
    P or N position ON
    Except above position OFF

    If NG, go to "DIAGNOSTIC PROCEDURE  ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Start engine and warm it up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    Fig 2: Identifying CONSULT-II Display Screen Data Monitor
    G02361039Courtesy of NISSAN MOTOR CO., U.S.A.
    ENG SPEED REFERENCE CHART

    ENG SPEED 1,000!- 6,375 rpm
    COOLAN TEMP/S More than 70°C(158°F)
    B/FUEL SCHDL 2.0 - 31.8 msec
    VHCL SPEED SE More than 64 km/h (40 MPH)
    Selector lever Suitable position
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
scientia non olet · About Mike's Workshop Manuals