Diagnostic Trouble Code (DTC) Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

Fig 1: Display A/T DTC Confirmation Procedure Sheet

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH CONSULT-II

Turn ignition switch ON and select "DATA MONITOR" mode for "A/T" with CONSULT-II.

Fig 2: CONSULT-II Display - Select "DATA MONITOR"
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Display A/T DTC Confirmation Procedure Sheet
Courtesy of NISSAN MOTOR CO., U.S.A.

If the check result is NG, Go to "DIAGNOSTIC PROCEDURE " .

If the check result is OK, go to following step.
Turn ignition switch ON and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
Start engine and maintain the following conditions for at least 3 consecutive seconds. Then release accelerator pedal completely.
VHCL SPEED SE: 10 km/h (6 MPH) or more

THRTL POS SEN (accelerator pedal position sensor):

Approximately 3V or less

Selector lever: D position

If the check result is NG, Go to "DIAGNOSTIC PROCEDURE " .

If the check result is OK, go to following step.

Fig 4: Display A/T DTC Confirmation Procedure Sheet
Courtesy of NISSAN MOTOR CO., U.S.A.
Maintain the following conditions for at least 3 consecutive seconds. Then release accelerator pedal completely.

VHCL SPEED SE: 10 km/h (6 MPH) or more

Accelerator pedal: Wide open throttle

Selector lever: D position

Fig 5: CONSULT-II Display - Select "DATA MONITOR"

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST

Follow the procedure "With CONSULT-II".