Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2004 >> I35 >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Can System (For VDC Models)) >> Can System (For VDC Models) >> Trouble Diagnoses >> Circuit Check Between VDC/TCS/Abs Control Unit And Steering Angle Sensor

Circuit Check Between VDC/TCS/Abs Control Unit And Steering Angle Sensor

WARNING: This page is about a different car, the 2003 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR 
    1. Turn ignition switch OFF.
    2. Check following terminals and connector for damage, bend and loose connection. (control unit-side, sensor-side and harness-side)
      • VDC/TCS/ABS control unit
      • Steering angle sensor
      • Between VDC/TCS/ABS control unit and steering angle sensor
    1. OK or NG 

    OK: GO TO 2.

    NG: Repair terminal or connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect VDC/TCS/ABS control unit connector and harness connector B58.
    2. Check continuity between VDC/TCS/ABS control unit harness connector B57 terminals 61 (L), 63 (R) and harness connector B58 terminals 9 (L), 20 (R).
      Fig 1: Checking Continuity Between VDC/TCS/ABS Control Unit Harness Connector B57 Terminals 61 (L), 63 (R) & Harness Connector B58 Terminals 9 (L) & 20 (R)
      G02092838Courtesy of NISSAN MOTOR CO., U.S.A.
    1. OK or NG 

    OK: GO TO 3.

    NG: Repair harness.

  3. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect steering angle sensor connector M218.
    2. Check continuity between harness connector M227 terminals 9 (L), 20 (R) and steering angle sensor harness connector M218 terminals 4 (L), 5 (R).
      Fig 2: Checking Continuity Between Harness Connector M227 Terminals 9 (L), 20 (R) & Steering Angle Sensor Harness Connector M218 Terminals 4 (L) & 5 (R)
      G02092839Courtesy of NISSAN MOTOR CO., U.S.A.
    1. OK or NG 

    OK: Connect all the connectors and diagnose again. Refer to "WORK FLOW  ".

    NG: Repair harness.