Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2004 >> G35 x >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> ID Registration Without Transmitter Activation Tool

ID Registration Without Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6. Adjust the tire pressures to the values specified in the ID Registration Tire Pressure Specifications  table.
    ID Registration Tire Pressure Specifications

    Tire Position Tire Pressure - psi (kPa)
    Front Left 34 (240)
    Front Right 31 (220)
    Rear Right 29 (200)
    Rear Left 26 (180)
  7. Drive the vehicle at more than 25 mph (40 km/h) for 3 minutes or longer.
  8. After the drive, and all IDs are registered, press "END" to complete the procedure.
  9. Inflate all tires to specification.
scientia non olet · About Mike's Workshop Manuals