ID Registration With Transmitter Activation Tool

1. With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
2. Select "START (NISSAN BASED VHCL)".
3. Touch "BCM" on "SELECT SYSTEM" screen.
4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
6. With the Transmitter Activation Tool (J-45295) pushed against the front left transmitter tire air valve, press the button for 5 seconds. See Fig 1.
   NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
7. Register the remaining IDs in the specified order: Front right, Rear right, Rear left. When ID registration of each wheel has been completed, a buzzer sounds, as indicated in the ID Registration Buzzer Specifications  table, and the turn signal light blinks twice.
   ID Registration Buzzer Specifications
   
   

   Tire Position	Buzzer Will Sound
   Front Left	Once
   Front Right	2 Times
   Rear Right	3 Times
   Rear Left	4 Times

8. After completing all ID registrations, press "END" to complete the procedure.

Fig 1: Identifying Transmitter Activation Tool (J-45295)

Courtesy of NISSAN MOTOR CO., U.S.A.