Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2004 >> G35 x >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (2004 - Engine Control System - Coupe) >> DTC P0452: EVAP Control System Pressure Sensor >> Diagnostic Trouble Code (DTC) Confirmation Procedure >> With GST

With GST

WARNING: This page is about a different variant/trim than selected.
  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
    Fig 1: DTC Confirmation Procedure (With GST)
    G00724169Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start engine and wait at least 20 seconds.
  5. Select "MODE 7" with GST.

    If 1st trip DTC is detected, go to "Diagnostic Procedure ".

scientia non olet · About Mike's Workshop Manuals