6. Check For EVAP Leak

With CONSULT-II 

1. Turn ignition switch ON.
2. Select "EVAP SYSTEM CLOSE" of "WORK SUPPORT" mode with CONSULT-II.
3. Touch "START" and apply pressure into the EVAP line until the pressure indicator reaches the middle of the bar graph.
   NOTE:

   • Never use compressed air or a high pressure pump.
   • Do not exceed 4.12 kPa (0.042 kg/cm² , 0.6 psi) of pressure in the system.
   Fig 1: CONSULT-II Display Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Using EVAP leak detector, locate the EVAP leak. For the leak detector, refer to the instruction manual for more details.
   Fig 2: Checking For EVAP Leak

   Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to "EVAPORATIVE EMISSION LINE DRAWING ".

OK or NG 

OK: GO TO 8.

NG: Repair or replace.