Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2004 >> FX35 AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis >> DTC Test Procedures >> DTC P0615: Start Signal Circuit >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode for "A/T" with CONSULT-II.
  3. Start engine.
  4. Drive vehicle for at least 2 consecutive seconds.
  5. If DTC is detected, go to DIAGNOSTIC PROCEDURE  .

scientia non olet · About Mike's Workshop Manuals