Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2004 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P1122: Electric Throttle Control Function Performance Problem >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2003 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect electric throttle control actuator harness connector. Check resistance between terminals No. 3 and 6. See Fig 1 . Resistance should be about 1-15 ohms at 77°F (25°C). If resistance is to specification, system is okay at this time. If resistance is not to specification, replace electric throttle control actuator and go to next step.
  2. Perform throttle valve closed position learning. See THROTTLE VALVE CLOSED POSITION LEARNING  under PROGRAMMING. Perform idle air volume learning. See IDLE AIR VOLUME LEARNING  under PROGRAMMING.
Fig 1: Identifying Electric Throttle Control Actuator Terminals
G00273023Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals