DTC Confirmation Test (With Generic Scan Tool)
WARNING: This page is about a different car, the 2003 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
- Start engine and warm it up to normal operating temperature.
- Check that voltage between ECM terminal No. 107 (fuel tank temperature sensor signal) and ground is less than 4.2 volts.
- Turn ignition switch off and wait at least 10 seconds.
- Start engine and wait at least 20 seconds. Select MODE 7. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.