Stop Lamp Switch (For M/T Models)

WARNING: This page is about a different variant/trim than selected.

Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.

STOP LAMP SWITCH CONTINUITY TEST CONDITION CHART

Condition	Continuity
When brake pedal is fully released.	Should not exist.
When brake pedal is depressed.	Should exist.

If NG, adjust stop lamp switch installation, and perform step 3 again.

Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2 (2-Terminal - M/T)

Courtesy of NISSAN MOTOR CO., U.S.A.