Power Window Lock Switch Circuit Check/With Front and Rear Power Window Anti-Pinch System

1. Turn ignition switch ON.
2. Check voltage between power window main switch connector D6 terminal 17 and ground.

Fig 1: Power Window Lock Signal Reference Data Table

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Voltage Between Connector D6 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : GO TO  3
2. NG : GO TO 2

Check continuity between power window main switch connector D6 terminal 15 and 17.

Fig 3: Power Window Lock Switch Reference Data Table

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Checking Continuity Between Connector D6 Terminals 15 And 17

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : GO TO 3.
2. NG : Replace power window main switch.

Check voltage between malfunction power window sub-switch terminal connector and ground.

Fig 5: Power Window Lock Signal Reference Data Table

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 6: Checking Voltage Between Malfunction Power Window Sub-Switch Terminal Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : Replace malfunction power window sub-switch
2. NG : GO TO 4

1. Turn ignition switch OFF.
2. Disconnect power window main switch and malfunction power window sub-switch connector.
3. Check continuity between power window main switch connector D6 terminal 17 and malfunction power window sub-switch connector D37 (passenger side), D55 (rear LH), D75 (rear RH), terminal 12.
   1. 17 (W) - 12 (Y/G or W): Continuity should exist. 

OK or NG 

1. OK : Replace malfunction power window sub-switch.
2. NG : Repair or replace harness between power window main switch and malfunction power window sub-switch.

Fig 7: Checking Continuity Between Connector D6 And Malfunction Power Window Sub-Switch

Courtesy of NISSAN MOTOR CO., U.S.A.