Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2003 >> G35 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Body Control Module - Coupe) >> BCM (Body Control Module) >> Removal and Installation of BCM >> Removal

Removal and Installation of BCM: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the dash side finisher (LH). Refer to "EXTERIOR & INTERIOR " article.
  2. Disconnect BCM connector.
  3. Remove bracket mounting screws (3) to remove BCM and fuse block with bracket.
    Fig 1: Locating Bracket Mounting Screws For Removing BCM
    G02058005Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Raise the pawl of fuse block and remove bracket from fuse block to remove BCM.
    Fig 2: Removing BCM
    G02058006Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals