Removal And Installation: Installation

To install, follow procedure for removal in reverse order.

CAUTION: Be careful of the following when installing ABS actuator and electric unit (control unit).

Tighten the mounting bolts and nuts to the specified torque.
After the work, bleed air from brake piping. Refer to BLEEDING BRAKE SYSTEM .
After installing vehicle harness connector in the actuator, make sure connector is securely locked.

NOTE:

After performing above works, calibrate decel G-sensor (AWD model). Refer to CALIBRATION OF DECEL G-SENSOR (AWD MODEL) .
In the case that ABS actuator and electric unit (control unit) are replaced, make sure to adjust position of steering angle sensor. Refer to ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION .