Test H: Abs Light Does Not Turn On When Ignition Is Turned On
- Check fuse No. 30 (10-amp) located in instrument panel fuse block. See Figure . If fuse is blown, replace fuse and retest. If fuse is okay, check ABS light bulb. Replace if necessary. If ABS light bulb is okay, go to next step.
- Turn ignition off. Disconnect ABS/TCS control unit 31 pin harness connector. See Figure . Turn ignition on. Measure voltage between ground and ABS/TCS control unit 31 pin harness connector terminal No. 21. See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, repair circuit between ABS/TCS control unit and fuse. See WIRING DIAGRAMS .