Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 1990 >> M30 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crank Angle Sensor (Q45) >> Removal & Installation

Removal & Installation

  1. Crank angle sensor is located on left front side of engine. Put aligning mark on crank angle sensor position before removing mounting screws. Disconnect harness connector. Remove mounting screws. Remove crank angle sensor.
  2. To install, reverse removal procedure. Ensure marks, made prior to removal, are aligned. Replace rubber "O" ring seal.
scientia non olet · About Mike's Workshop Manuals