(Inhibitor Switch Removal And Installation)
ABBREVIATED PROCEDURE
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery (-) terminal | - | - | - | - | - |
| 2 | Make sure vehicle does not roll before setting shift lever to "N" position | - | - | - | - | - |
| 3 | Remove the air cleaner assembly and air duct (Refer to Engine Mechanical System - "AIR CLEANER ") |
- | - | - | - | - |
| 4 | Disconnect the inhibitor switch connector | - | - | - | - | - |
| 5 | Loosen the shift cable nut | - | - | - | - | - |
| 6 | Remove the manual control lever after loosening the nut | - | - | - | - | - |
| 7 | Remove the inhibitor assembly after loosening the bolts | - | - | - | - | - |
|
||||||
| 1 | Check that the shift lever is placed in the "N" position | - | - | - | - | - |
| 2 | Lightly tighten the inhibitor switch bolts after installing the inhibitor switch | - | - | - | - | - |
| 3 | Lightly tighten the manual control lever nut after installing the manual control lever | - | - | - | - | - |
| 4 | Align the hole in the manual control lever with the "N" position hole of the inhibitor switch and then insert the inhibitor switch guide pin (09480-A3800) | - | - | 09480-A3800 | - | - |
| 5 | Tighten the nut and bolts with the specified torque | Bolt Nut |
|
- | - | Refer to appropriate service information |
| 6 | Lightly tighten the nut after connecting the shift cable in the manual control lever | - | - | - | - | - |
| 7 | Push shift cable lightly to "F" direction shown to eliminate free play of shift cable | - | - | - | - | - |
| 8 | Tighten the nut with the specified torque | Nut | 9.8 - 13.7 (1.0 - 1.4/7.2 - 10.1) | - | - | - |
| 9 | 9. Remove the inhibitor switch guide pin (09480-A3800) from the hole. | - | - | - | - | - |
| 10 | Connect the inhibitor switch connector | - | - | - | - | - |
| 11 | Install the air cleaner and air duct (Refer to Engine Mechanical System - "AIR CLEANER ") |
- | - | - | - | - |