(Shift Cable Removal And Installation)

ABBREVIATED PROCEDURE

Work		H/W	Tightening torque N.m (kgf.m/lb-ft)	SST/Equipment	Chemical	etc
Removal
1	Disconnect the battery (-) terminal	-	-	-	-	-
2	Remove the air cleaner and air duct (Refer to Engine Mechanical System - "AIR CLEANER ")	-	-	-	-	-
3	Remove the ECM (Refer to Engine Control/Fuel System - ECM - "REMOVAL ")	-	-	-	-	-
4	Remove the battery and battery tray (Refer to Engine Electrical System - Battery - "REMOVAL ")	-	-	-	-	-
5	Remove the shift cable from the cable bracket, after loosening the nut	-	-	-	-	-
6	Remove the shift lever knob & boots (A) and pull both up	-	-	-	-	-
7	Remove the floor console assembly (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ASSEMBLY ")	-	-	-	-	-
8	Remove the shift cable after removing the snap pin	-	-	-	-	-
9	Remove the retainer by loosening the nuts	-	-	-	-	-
10	Remove the shift cable from the vehicle	-	-	-	-	-
Installation
1	Install the retainer and then tighten the nut	Nut	11.8 - 14.7 (1.2 - 1.5/8.7 - 10.8)	-	-	-
2	Install the shift cable and then fix the snap pin	-	-	-	-	Refer to appropriate service information
3	Install the floor console assembly (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ASSEMBLY ")	-	-	-	-	-
4	Install the shift lever knob & boots	-	-	-	-	-
5	Install the shift cable in the cable bracket	-	-	-	-	-
6	Align the hole in the manual control lever with the "N" position hole of the Position switch and then insert the Position switch guide pin (09480-A3800)	-	-	-	-	-
7	Lightly tighten the nut after connecting the shift cable in the manual control lever	-	-	-	-	-
8	Push shift cable lightly to "F" direction shown to eliminate free play of shift cable	-	-	-	-	-
9	Tighten the nut with the specified torque	-	9.8 - 13.7 (1.0 - 1.4/7.2 - 10.1)	-	-	-
10	Remove the Position switch guide pin (09480-A3800) from the hole	-	-	-	-	-
11	Install the battery and tray (Refer to Engine Electrical System - Battery - "REMOVAL ")	-	-	-	-	-
12	Install the ECM (Refer to Engine Control/Fuel System - ECM - "INSTALLATION ")	-	-	-	-	-
13	Install the air cleaner assembly and air duct (Refer to Engine Mechanical System - "AIR CLEANER ")	-	-	-	-	-