Terminal And Connection Inspection
- Disconnect CRUISE REMOCON SWITCH and the ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
- Connect the GDS and go to "Current Data".
- Monitor CRUISE REMOCON SWITCH values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
- Any change in the values indicates a poor connection. Was a connector problem found?
YES
- Repair the connector. Go to "VERIFICATION OF REPAIR " procedure.
NO
- Go to next step below.
| Check Item | Specifications | Prerequisite Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Power Circuit - Voltage | 11.5V to 13.0V |
|
CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness | Chassis GND |
- Is the measured value within specification?
YES
- Go to "SIGNAL CIRCUIT INSPECTION".
NO
- Repair short to ground/open between 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Cruise supply' terminal of ECM harness connector, and go to "VERIFICATION OF REPAIR " procedure.