Common Specs & Procedure Index

KONA COMMON SPECS & PROCEDURES

System		Specification/Procedure
Air Conditioning
Service		SPECIFICATIONS
Torque		Refer to TIGHTENING TORQUES
Axle Nut/Hub Nut
Front
	LH	274.6-294.2 N.m (28.0-30.0 kgf.m, 202.5-217.1 lb-ft)
	RH	274.6-294.2 N.m (28.0-30.0 kgf.m, 202.5-217.1 lb-ft)
Rear (4WD)		274.6-294.2 N.m (28.0-30.0 kgf.m, 202.5-217.1 lb-ft)
Battery		See BATTERY (1.6L) or BATTERY (2.0L)
Brakes
Bleeding Sequence		BRAKE BLEEDING PROCEDURES
Disc/Drum Brakes
Service Specifications		SPECIFICATIONS
Torque		Refer to TIGHTENING TORQUES .
Charging
Generator		Refer to ALTERNATOR (1.6L) or ALTERNATOR (2.0L)
Torque		Refer to Tightening Torque values given in ALTERNATOR (1.6L) Repair Procedures or ALTERNATOR (2.0L) Repair Procedures.
Drive Belts
Adjustment
Generator Belt		Automatic tensioner; Refer to DRIVE BELT (1.6L) or DRIVE BELT (2.0L)
Engine Cooling
General Service Specifications		Refer to Cooling System in table under SPECIFICATIONS (1.6L) or SPECIFICATIONS (2.0L) .
Radiator Cap Pressure		13.51-17.78 psi
Thermostat R & I		INTEGRATED THERMAL MANAGEMENT MODULE (ITM) (1.6L) or INTEGRATED THERMAL MANAGEMENT MODULE (ITM) (2.0L)
Water Pump R & I		WATER PUMP (1.6L) or WATER PUMP (2.0L)
Engine Mechanical
Compression		COMPRESSION PRESSURE INSPECTION (1.6L) or COMPRESSION PRESSURE INSPECTION (2.0L)
Oil pressure (at 1, 000 RPM)		1.6L : 90.22 kPa (0.92 kg/cm² , 13.09 psi) or above 2.0L : 90.22 kPa (0.92 kg/cm² , 13.09 psi) or above
Overhaul		SPECIFICATIONS (1.6L) or SPECIFICATIONS (2.0L)
Torque		TIGHTENING TORQUES (1.6L) or TIGHTENING TORQUES (2.0L)
Fluid Specifications		See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque		1.6L : 52.8-55.7 Ft. Lbs. (71.5-75.5 N.m) 2.0L : 90.4 - 97.6 Ft. Lbs. (122.6 - 132.4 N.m)
Fuel System
Pressure Specification		1.6L : 69.6 - 75.4 psi (480 - 520 kPa) 2.0L : 48.3 - 51.2 psi (333 - 353 kPa)
Fuel Pressure Test Procedure		FUEL PRESSURE TEST (1.6L) or FUEL PRESSURE TEST (2.0L)
Fuel Filter Location		In fuel pump assembly.
Fuel Filter R & I		FUEL FILTER (1.6L) or FUEL FILTER (2.0L)
Ignition
Firing Order & Cylinder Identification		1-3-4-2. Also refer to FIRING ORDER & CYLINDER IDENTIFICATION .
Spark Plug
Type		1.6L : SILZKR8J8GS 2.0L : SILZKR7L11S
Gap		1.6L : 0.0276 - 0.0315 in. (0.7 - 0.8 mm) 2.0L : 0.0394 - 0.0433 in. (1.0 - 1.1 mm)
Torque		1.6L & 2.0L : 10.9-18.0 ft. lbs. (14.7-24.5 N.m)
Starting
Starter		See STARTER (1.6L) or STARTER (2.0L) .
Torque		1.6L & 2.0L : 49.0-63.7 N.m (5.0-6.5 kgf.m, 36.2-47.0 lb-ft)
Wheel Alignment
Adjustment Specifications		WHEEL ALIGNMENT (2WD) or WHEEL ALIGNMENT (4WD)
Torque		TIGHTENING TORQUE (2WD) or TIGHTENING TORQUE (4WD)
Wheel & Tire
Wheel Lug Nut Torque		79.6-94.0 ft. lbs. (107.9-127.5 N.m)